Lighting the path ahead of you

standard h8 angel eye upgrade e92 m3

Not all angel eye upgrades are the same!

This BMW M3 (E92) came in with an aftermarket H8 angel eye conversion, which to be honest is miles better than the original factory fitted angel eyes that come standard with with most new BMW’s  particularly the E92 BMW.

If you are going to buy a car like this, get the upgrades your car deserves.

Autolights.co.uk upgraded the entire interior, inside of the boot and even put in better H8 angel eye upgrade Led components.

See the image below.

AUTOLIGHTS h8 angel eye upgrade e92 m3

Once we finished with the E92 M3, the angel eyes were exactly what the customer was after!

Our H8 canbus angel eye upgrade is considerably brighter than whats on the market, sure, most of the angel eye upgrades look the same, but as you know by now, looks can be deceiving.

The finished article is the BMW E92 M3 the way you know its meant to be!

Get the look: H8 angel eye upgrade

For more information, please contact us: 0207 183 3090

 Hid conversions do not get more simpler than this.

This Bmw E46 (3 series) opted for a H7 hid conversion for the dipped beam.

We also converted the fog lights with a 9006 (HB4) hid kit, also 600k.

Since this E46 model had projector lenses there was no requirement for an additional E46 bulb holder  as per the non projector model.

The fog lights can be removed by removing the shroud on the front and undoing the relevant bolts.

For further information please contact us on 0207 183 3090

5 Series E60 HID CONVERSION H7R 6000k Dipped Beam and Fog Lights

BMW E60 5 Series.

This 5 Series which comes with the reflector lens (non – projector), had the H7R anti glare canbus hid kit fitted with obc units.

The fogs had a 9006 hid kit upgrade.

The parking lights  were upgraded by the use of T10 canbus led bulbs.

The interior was also upgraded as were  the number plate lights with Can Bus festoon Led bulbs.

Installation – Its really quite straight forward.

1. Remove the rubber strip that runs above the grill (between the hood and the grill).

2. Remove 2 torque screws from each side (the two outer most, total removed = 4), this will allow you to flex the top of the grill, making it easier to remove the E60′s headlamp and install a HID kit.

3. on the rear of the head lamp housing remove the inner dust caps.

4. Each head light housing will now have 4 Torque screws, Two on the top – remove these completely. the other two are behind the headlamp slightly lower, you can also use an 8mm socket set (loosen these screws only – do not remove them)

5. Twist the headlamp out and insert the HID components.

6. Put it all back together again.

Get the look:

H7 HID KIT

OBC units

T10 Canbus

Interior lighting

Festoon Canbus

For further information please contact us – 0207 183 3090

Autolights canbus pro HID KIT for the bmw E90 3 series.

Autolights has supplied and installed numerous hid kits for this BMW 3 series model.

When installing this kit, it is advisable to gain access through the access points in the wheel arh on wither side.

Simply replace the H7 halogen bulbs with the H7 Hid kit.

Side light upgrades used for this car are the T10 canbus led bulbs

Number plate upgrades used for this car are the Canbus festoon led bulbs (39mm)

For more information please contact us on 0207 183 3090

BMW Z4 xenonConversion - 6000k

Autolights fitted this BMW Sports convertible with a H7 Hid  kit (6000k)

In order to fit the hid conversion kit to this car, access was gained via the access flap on either side.

The H7 halogen bulb was replaced with an autolights hid conversion kit with the 6000k colour.

The side lights were also replaced with the T10 Canbus Led.

The number plate lights were also replaced with the T10 Canbus led light.

NOTE: This particular model much like the BMW 1 series has a distinct problem with condensation, so we strongly suggest that after placing the H7 hid kit, and replacing the cover back, you use a sealant around the cover to prevent excessive mositure from getting inside the head lampl housing.

Get the look - BMW Z4 HID KIT

Side lights – T10 canbus

For more information please contact us on 0207 183 3090

BMW 1 Series hid conversion kit by Autolights.

No on board errors,  no flickering.

The autolights canbus pro hid kit is a simple plug and play kit, and is well equipped for the bmw 1 series.

When installing autolights canbus pro hid kit, there is no need toremove the headlight completeley, simply remove the back cover and replace the halogen H7 bulb with a H7 hid bulb from the canbus pro hid kit.

And changing the side lights to Led are just as simple, just remove the T10 / 501 halogen bulbs and replace with the T10 canbus led bulbs.

The hid kit installed in this car was a H7R (anti glare) 6000k canbus pro slim line kit.

Do not forget to replace the cover on the back of the light!

NOTE: This particular model much like the BMW Z4 has a distinct problem with condensation, so we strongly suggest that after placing the H7 hid kit, and replacing the cover back, you use a sealant around the cover to prevent excessive mositure from getting inside the head lampl housing.

For further information please call:- 0207 183 3090